- This topic has 1 reply, 2 voices, and was last updated 20 years, 12 months ago by
Retired plbg1.
Viewing 1 reply thread
-
Posts
-
-
MasterPlumbers
I just installed new faucet in one sink and garbage disposal in another. In both cases, the pipes leaked. I tightened the plastic compression rings, made sure there were seals where needed, etc. But still small leaks, especially after the sink that I had filled had emptied. It would look good, then I’d look again after a few minutes and there would be a small puddle on the floor of the sink cabinet. Any ideas of what I am doing wrong. Thanks
-
Put new washers in trap and try it, make sure trap is lined up good before you make it tight, tighten up by hand and then get plyers and make a 1/4 turn, if it dont work get telflon dope and take apart and put some on threads and pipe. If you made them to tight you might have cracked the nut.
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
