Three handle shower/bath faucet

Home › Forums › Public Forums › General Plumbing › Three handle shower/bath faucet

Viewing 1 reply thread
  • Author
    Posts
    • 7 Nov 2004 at 5:18 pm #277406
      Avatar photoChris2001
      Member

      Was considering replacing a 3 handle shower faucet with a new one. My question is can I use compression fittings when installing the new one, because the access area is very tight and soldering would be somewhat difficult. The supply lines are 1/2 inch copper.

      » This message has been edited by Pete224 on 07 November 2004

    • 7 Nov 2004 at 11:49 pm #296145
      Avatar photoRetired plbg1
      Participant

      You could but I would not use them in wall I would solder them. You could use a sweat union, sweat one side of union inwall and solder other side to valve pipe.


      Art retired plbg

  • Author
    Posts
Viewing 1 reply thread
  • You must be logged in to reply to this topic.