- This topic has 1 reply, 2 voices, and was last updated 23 years, 3 months ago by
.
Viewing 1 reply thread
-
Posts
-
-
I have a Master Plumber water heater. I’ts about 5 years old. I have no hot water. I’ve replaced both elements and thermostats, and there is power going to the tank and to each thermostat and element. Is there anything I am not checking? Please let me know before I go buy a whole new tank. Thank you. BB41272@adelphia.net
-
Check if there is power going from the thermostat ouput terminals to the element/s themselves. If so isolate the power supply and then check the resistances of each of the elements.
If everything checks out ok the elements should then be working and power going through them to heat up the water.
Selgas Services Ltd
Craftsman Gasfitters, Plumbers, Electrical Service Technicians
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
