- This topic has 1 reply, 2 voices, and was last updated 22 years, 8 months ago by
SylvanLMP.
Viewing 1 reply thread
-
Posts
-
-
MasterPlumbers
Any suggestions on how to loosen 100 y/o bolts on older Radiators? I have a one pipe steam system with a leaky unit. It seems simple enough to swap out a Radiator but I can’t seem to loosen the nut that holds it in. The valve was replaced recently (I just bought the house) it’s new and I can see the teflon tape that was used. Any tricks to getting these thing off would be appreciated.
Thanks -
If your talking about the rods that hold the sections together just use a sawzall or bolt cutter THEN separate the sections so it is more manageable to take away.
If your talking the bolts that hold rads against the wall use a lump hammer and cold chisel BECAREFUL to break the bolt head.
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
