- This topic has 1 reply, 2 voices, and was last updated 22 years, 6 months ago by
fourth year.
Viewing 1 reply thread
-
Posts
-
-
MasterPlumbers
I recently cut and soldered some joints but failed to removed to internal burr from the tube. I have now read that this will cause turbulence and lead to corrosion of the copper. Is this true? Do I need to take the joints apart and re-do them?
-
It is a judgment call on your part. If the pipes are large enough that the velocity is low, there should not be a problem. Hot water is more likely to have the problem if erosion were to occur.
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
