toilet seal problem if floor is raised 1″

Home Forums Archives Old Bulletin Board Archives toilet seal problem if floor is raised 1″

Viewing 1 reply thread
  • Author
    Posts
    • #282756
      Avatar photoOllie K

        I am replacing the linolium floor in the bathroom with ceramic tile. With the cement backer board and the tile, the floor will be up to 1 higher. How do I then get a good seal when I replace the toilet?

      • #305738
        Avatar photoDavid Truman
        Participant

          NO PROBLEM JUST SET YOUR FLOOR AND LEAVE ENOUGH ROOM ARROUND THE CLOSET RING AND AFTER YOU ARE DO WITH THE TILE JOB YOU CAN BUY A CLOSE RING EXTENSIONS.. IT IS MAKE BY PASCO AND IT WILL COME WITH RINGS THAT GO OVER YOUR EXISTING RING AND YOUR CAN USE THEM TO BRING THE CLOSET RING UP TO THE PROPER LEVEL. IT WILL ALSO COME WITH LONG CLOSET BOLTS TO INSTALL YOUR TOILET.. YOU CAN ALSO USE TWO WAX RINGS AND LONG BOLTS, BUT NOT AS GOOD OF A SEAL..GOOD LUCK YOUR FRIEND THE PIPEXPERT….

      Viewing 1 reply thread
      • The forum ‘Old Bulletin Board Archives’ is closed to new topics and replies.

      Pin It on Pinterest

      Share This