Soldering Copper

Home Forums Archives Old Bulletin Board Archives Soldering Copper

Viewing 1 reply thread
  • Author
    Posts
    • #282859
      Avatar photopapiver

        I have soldered a good amount of copper pipe. Normally I have no problem; however, once in a while the solder simply will not stick to the connection. Its hot enough because the solder melts, but it just drips off the connection in balls. Is it too hot?

      • #303470
        Avatar photoScott Modery
        Participant

          It is not clean, there is not enough flux on the two pieces, or there is moisture in the pipe.: I have soldered a good amount of copper pipe. Normally I have no problem; however, : once in a while the solder simply will not stick to the connection. Its hot enough : because the solder melts, but it just drips off the connection in balls. Is it too hot?

      Viewing 1 reply thread
      • The forum ‘Old Bulletin Board Archives’ is closed to new topics and replies.

      Pin It on Pinterest

      Share This