Priming a pump

Home Forums Public Forums General Plumbing Priming a pump

  • This topic has 1 reply, 2 voices, and was last updated 22 years ago by daveroconn.
Viewing 1 reply thread
  • Author
    • #273167

      what is the proper way to prime a pump or how do you tell if the dang well has gone dry?
      AL :?)

    • #287016

      Make sure water is all the way up to the pump before starting the motor. Use a pressure guage on the outlet side of the pump. If you ran it dry you may have damaged it. Pumps cannot be run dry for any length of time.

      As fer as your other post. Water is sucked into the pump by suction. Most pumps cannot suck more than 20-25 feet.

Viewing 1 reply thread
  • You must be logged in to reply to this topic.

Pin It on Pinterest

Share This