Reply To: Drilled a hole in a PVC pipe

Home Forums Public Forums General Plumbing Drilled a hole in a PVC pipe Reply To: Drilled a hole in a PVC pipe

#293110
bungie
Participant

I did miss read it.

cut a piece of the same size pipe long enough to cover the hole and at least 3/4 inch each side of the hole. Split the pipe along the length. ensure the pipe with the hole is dry, use plenty of cleaner and then glue over the pipe. Open the new cut section of pipe so that it can be placed over the older piece and wrap its self around the old pipe. It will snap into place around the old pipe and seal as long as the old pipe was dry.

This can also be done using silicone instead on solvent cement.



DISCLAIMER

All advice is given with-out seeing the job, and hence all advice MUST be taken as advice with limited knowledge on the exact situation. NO responsibility can or will be taken. And yes, I am a licensed Plumber and Drainer with my own business in Brisbane Australia.
Try visiting ….
Macadamia nuts and Aussie productsProstate cancer kills 2600 per/year in AustraliaEcommerce books

Pin It on Pinterest

Share This