Home › Forums › Public Forums › General Plumbing › new install hot water heater…gas… › Reply To: new install hot water heater…gas…
5 Jun 2002 at 4:22 am
#292512
Bruce T
Participant
pull the little plastic cover from around the factory installed drain and check the threads, as well as the factory installed T and P valve, anode rod and maybe where the gas valve is screwed into the tank. ..sometimes even the factory screws up!
and check the discharge of the T&P valve because of thermal expansion…
I think thats what NICK is saying…HAHAHA!
» This message has been edited by Bruce T on 05 June 2002