- This topic has 1 reply, 2 voices, and was last updated 25 years, 4 months ago by
Bob Craddock.
-
Posts
-
-
L C Morongell
Is there any way to get apart a solvent glued pipe fitting in an existing ABS drain pipe? Because of a tight dimensional area I need to be able to break apart the fitted joint rather than cutting the pipe and adding an addional fitting. I would appreciate any advice you could lend. Thank you, Bob Craddock
-
There is a fitting called a fernco hub to pipe coupling that fits over the hub so you do not have to cut the fitting out and mess up the wall As a way to get a fitting apart good luck in my 15 years I have yet to get one apart without destroying it. : Is there any way to get apart a solvent glued pipe fitting in an existing ABS drain pipe? Because of a tight dimensional area I need to be able to break apart the fitted joint rather than cutting the pipe and adding an addional fitting. I would appreciate any advice you could lend. : Thank you, : Bob Craddock
-
- The forum ‘Old Bulletin Board Archives’ is closed to new topics and replies.
