- This topic has 2 replies, 2 voices, and was last updated 23 years, 10 months ago by
DP.
-
Posts
-
-
MasterPlumbers
I bought an old house in France and am in the process of renovating it. I’ve found that I can purchase fixtures much less expensively here in the U.S. than I can there. My question is; Does anyone know if there are connectors available that go from 3/8″ and 1/2″ to their respective metric sizes? Or any other suggestions re:connecting american
taps, shower valves etc. to metric
supply lines?
Thanks
John Dufurrena -
quote:
Originally posted by baskodoc:
I bought an old house in France and am in the process of renovating it. I’ve found that I can purchase fixtures much less expensively here in the U.S. than I can there. My question is; Does anyone know if there are connectors available that go from 3/8″ and 1/2″ to their respective metric sizes? Or any other suggestions re:connecting american
taps, shower valves etc. to metric
supply lines?
Thanks
John Dufurrena
-
3/8″ and 1/2″ male iron and female irons are standard adapters with the other end at 15mm. I cannot see a problem as far as fittings are concerned. You may find fitting onto a bathtub a problem as majority bath mixers are wall mounted- but then again these can be converted. Connections are at 150mm for wall mounted.
Sorry about the double posting.
quote:
Originally posted by baskodoc:
I bought an old house in France and am in the process of renovating it. I’ve found that I can purchase fixtures much less expensively here in the U.S. than I can there. My question is; Does anyone know if there are connectors available that go from 3/8″ and 1/2″ to their respective metric sizes? Or any other suggestions re:connecting american
taps, shower valves etc. to metric
supply lines?
Thanks
John Dufurrena
-
- You must be logged in to reply to this topic.
