- This topic has 5 replies, 6 voices, and was last updated 24 years, 7 months ago by
daveroconn.
-
Posts
-
-
Anonymous
I am having low water pressure in my kitchen sink. The other faucets, showers, etc are fine. It is affecting only the sink, both
hot and cold water.If I start with one temperature water, then turn on the other, there
is no noticeable increase in the
pressure. We have a sprayer attached, and that seems to be working fine. But I don’t know if that would be normal, considering how
apparent water pressure increases when
you put your finger over a hose.I’m not certain what type of piping
I have.Any help would be appreciated.
Thanks,
Joe -
Joe take off your aerator and clean it then reinstall and your back in business
SylvanLMP -
I’m having the same problem with my bathroom sink. And all I get is hot water, not cold, unless I turn the hot water off at the wall. Could the faucet itself have gone bad? Where the water mixes?
-
OK, I forgot to mention that part
<sheepish grin>. I remove the
aerator the water pressure withOUT
it is roughly the same. Also,
no change if I start with one temp
and add the other.Joe
-
Sometimes the diverter for the hand held sprayer will clog up and cause poor preasure out the spout but not affect the preasure at the sprayer. The diverter is located at the base of the spout. To be sure the problem is just in the faucet, you can turn off the supply stops, take the stem out of the H or C side, hold a cup over it to divert the water into the sink, open the supply stop and see how your preasure is. If your preasure is good here you know the problem is somewhere in your faucet.
-
If you turn the sprayer on does the water divert from the faucet to the sprayer? Or does it continue to run out of the faucet and sprayer at the same time? If the latter is correct the diverter inside your faucet is bad and should be cleaned/repaired/ replaced.
-
- You must be logged in to reply to this topic.
