Piping Burnham hot water circulating cast iron baseboard radiation

Home › Forums › Public Forums › General Plumbing › Piping Burnham hot water circulating cast iron baseboard radiation

• This topic has 1 reply, 2 voices, and was last updated 24 years, 9 months ago by hj.

Viewing 1 reply thread

• Author
  Posts
• • 13 Feb 2000 at 10:05 pm #272465
    MasterPlumbers

    Keymaster

    I am installing (2)10′, (1)7′, & (2)5′ sections of baseboard in basement. Should each section be piped separately? Can all sections be piped in on series loop? If so, can I pipe the supply in bottom fitting and return on top fitting? Does each section need a bleeder valve on it? If this is the case I cannot pipe return on top fitting. Basically what is the proper installation?

  • 13 Feb 2000 at 11:04 pm #285784
    hj

    Participant

    You can use the bottom openings for both supply and return. Each radiator has to have its own air vent installed on one of the top openings.

• Author
  Posts

Viewing 1 reply thread

• You must be logged in to reply to this topic.

Log In

Username:

Password:

Keep me signed in

Log In