kenmore model 70 washing machine

[JoeChoniski]

washing machine wont spin. where do i start to look for the possible problem. thanks

[patParticipant]

: washing machine wont spin. where do i start to look for : the possible problem. thanks

[patParticipant]

: : washing machine wont spin. where do i start to look for : : the possible problem. thanks

[patParticipant]

: : : am looking for be a service rep. in my area, I have a apliances repair service in Orange County in Orlando FL

[patParticipant]

washing machine is leaking water. What are the possible causes. It is making the floor wet during the washing cycle. Otherwise it is working okay.

[patParticipant]

: washing machine wont spin. where do i start to look for : the possible problem. thanks

[patParticipant]

washing machine wishywashing is not working. Switching rod poped to far forward. The rod that switches the pump from drain to free spin. What is the way of fixing it? Thanks

[patParticipant]

I have an old Sear Kenmore washer. It is probably at least 15 years old. I believe it is a Model 70 (I can barely make it out on the front control panel) The engraved Model number on the little plate on the front bottom left side of the machine is: 72675610.Most of the lettering and numbering is worn off. At one time, there was (what seemed to be) a photocopy (perhaps from some owners manual) of the control panel taped around the main timer knob. Now, its gone.I need a picture of some sort that shows the lettering and numbering on the control panel for each of the 3 knobs. I believe these knobs (from left to right) are:1. Water Level (3 postions – LOW, MED, HIGH) 2. Main Timer Knob (I remember a Permanent Press setting, and timed settings) 3. Water temperature (5 or 6 positions? Warm/warm, warm/cold, cold/cold, etc)I couldnt get any help from Sears. Does anybody have any suggestions? Can anybody scan some pages from their manual and send them to me? Please reply to me personally.Thanks in advance.

[patParticipant]

: washing machine wont drain. where do i start to look for : the possible problem. thanks

[patParticipant]

: washing machine wont spin. where do i start to look for : the possible problem. thanks

[patParticipant]

: : washing machine wont spin. where do i start to look for : : the possible problem. thankscheck rubber coupling between motor and drive

[patParticipant]

My washer wont spoin or agitate, it just makes a loud buzzing noise. What would the problem be?

[patParticipant]

: My washer wont spoin or agitate, it just makes a loud buzzing noise. What would the problem be?

[patParticipant]

My washing Machine spins slow when trying to wash. Can you help.

[patParticipant]

: washing machine wont spin. where do i start to look for : the possible problem. thanks

[patParticipant]

: : : washing machine wont spin. where do i start to look for : : the possible problem. thanks

[patParticipant]

my washing machine is locked up and i dont know how to fix it

[patParticipant]

kenmore washer wont drain. when moving drive belt by hand the shaft on the pump appears locked up. should pump be replaced? could something be inside the pump? can bushings be replaced or should the whole assembly be thrown out?

[patParticipant]

: Washing machine spin, but nothing move or turns around. Where do I start to look for the possible problem. Thanks

[Author]

Posts