- This topic has 2 replies, 3 voices, and was last updated 12 years, 6 months ago by
james121.
-
Posts
-
-
James Read
Hi there –
I am a landlord, not a plumber, but thought it should be simple enough to replace a universal tub spout with a new one.
Unfortunately this thing had been in a place for a long time and wasn’t budging no matter what I tried, so I took a hacksaw to it. Now I still can’t seem to remove the part of the spout body which is threaded onto the end of the pipe.
Any advice how to get this off without screwing up anything else?
A photo is at the URL below – (I could not get it to embed here)
Thanks.
-
It looks like you have a 1/2″ sweated copper male-threaded adapter onto which the pot-metal tub spigot (the part you hackswaed out) was screwed. If so, don’t try to use a pipe wrench to twist it apart. You’ll need to heat up the male adapter with a torch to melt the solder and caefully pull the adapter off with Channel-Lock pliers. Then snad down and clean the end of the horizontal copper pipe section, resolder on a new male adapter, and then screw on the replacement spigot.
Looks like there is a lot of corrosion at the end of the pipe, and hopefully its just at the end where the old spigot was attached.
If you are careful, you won’t damage the proximal ends of the connection, but don’t count on it. If you can’t fix it using my suggested technique, you’ll have to get behind the tub somehow. The best way to do that would be to get access to the wall behind the tub.
Good luck,
NtP
-
You can also tie thick cloths for the spout.
-
- You must be logged in to reply to this topic.
