Home › Forums › Public Forums › General Plumbing › Brazing copper pipes › Reply To: Brazing copper pipes
when soldering two copper lines together the best way i can explain to my help is when you sand the copper it needs to look like a shiny penny. then put the solder past in the cuppling and around both coppers. when soldering the tip of the blue flame is the hottest so when soldering keep your flame close to the copper as you heat the copper go left to right every few seconds touch the solder to the edge of the coupling when heat is just right the solder will melt to the touch . slowly back the torch away . when you see a drip of solder the couppling is full . also if you over heat it will spit out the solder. another thing to know is where ever you put the heat the solder will go to .if your lines are expose you can by pass all this by useing jcupplig from any plumbing hardware . this is a fitting with to nuts and washer comes in brass or p.v.c
