Home › Forums › Public Forums › General Plumbing › Dishwasher hook-up, sink necessary? › Reply To: Dishwasher hook-up, sink necessary?
Hi Vince, depending on local codes I cannot see any problem installing a D/W waste to an 11/2″ standpipe that is properly trapped and vented. The new dishwashers (most) have a built in Air Gap fitting built inside and the use an of another an air gap may not be required if you raise the discharge piping above the D/W.
( check local codes)
Of course it wouldnt hurt to put in an Air Break fitting also for added protection .
Now you menthioned using an 11/2″ drain for a washing machine I would opt for no less than a 2″ stand pipe, and an Air Break is also “required” for the discharge of a washing machine.
Alot of folks fail to realize both washing machines/ Dishwashers come in contact with potable water and drainage lines, so the possibility of a cross connection is very real.
The reason for a 2″ stand pipe is volume needed for proper discharge and velocity not to exceed more than 3-5 FPS. Another valid reason to increase the pipe to 2″ is the build up of grease (dish washer) and soap scum (washing machine)which will cause a reduction in internal piping diameter in a short period of time.
You maybe able to pipe both the D/W and W/M through a WYE fitting using an Air Break fitting (Air break = drainage) Air Gap = water supply. This should pass any code in the country. Have a great one SylvanLMP
SylvanLMP
[Edited by SylvanLMP on 02 April 2000]
